If this is your first visit to the Roth Army, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
of course you know that if you use only 2 springs, you attach at the blocks' 2 outer holes, then pull with needle nosed pliers to push the spring eyelet down over the 2nd most inner pair of claw fingers?
The Yngwie way was to attach 3 straight.. 2 on the low E side straight across side by side, then 1 at the 2nd from the outermost hole parallel to the 2nd outermost claw finger.
Yeah, instead of pulling with needle pliers I used my finners ... and fuck yngwie! ... lofl
why is it that my bottom 3 strings do a half note bend when I do a "trill" with the highest 2 strings? ... bridge out of line? My bottom half of the trem IS about 2 widths higher than higher ...
Comment